Cupra TERRAMAR 2024 - Rear Cross Traffic Alert); How It Works

Parking and manoeuvring
255
Rear Cross Traic Alert)
1)
It is only displayed if the vehicle is equipped with a parking system.
●
Changes have been made to the paint in the
camera area and structural modications have
been made, e.g. to the front part of the vehicle
and the running gear.
Solution for all cases
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the system still behaves unpredictably,
have it checked by a specialised workshop.
Rear Cross Traic Alert)
How it works
Fig.164 Diagram of the parking assistant:
detected area around the vehicle that is
driving o.
Park Assist uses the radar sensors on the rear
bumper ›››page195 to monitor traic cross-
ing behind the vehicle as it reverses out of a
parking bay, or as it is being manoeuvred, for
example in very low visibility conditions.
When the system detects a relevant vehicle on
the road that is approaching the rear of the
vehicle ›››Fig.164, an acoustic alarm may
sound if the relevance so requires it.
In addition to the acoustic alarm, the driver is
also informed by means of a visual signal on
infotainment system display. This signal is dis-
played in the form of a red strip at the back of
the image of the vehicle on the infotainment
system screen. This strip displays the side of
the vehicle towards which traic is approach-
ing in transverse direction
1)
.
Automatic braking to reduce damages
›››page228.
Connecting and disconnecting
The rear cross traic alert can be activated
and deactivated by accessing the Assistants
menu of the infotainment system. It can also
be found in the Park Assist Settings menu.
Additionally it can be switched on and o by
accessing the Assistants menu on the instru-
ment cluster.
When the vehicle is restarted, the last adjust-
ment in the system will remain active.
Trailer mode
The rear cross traic alert will be automatically
deactivated and it will be impossible to activate
them if the tow hitch is electrically connected
to a trailer or other similar object. As soon as
the driver starts driving, a message appears on
the instrument cluster screen indicating that
the assistant is deactivated.