Cupra TERRAMAR 2024 - Troubleshooting

28
Driver information
●
If the ignition is switched o.
●
The driver's seat belt is unbuckled and the
driver's door is open.
●
The vehicle has been stopped for more than
30 minutes.
Driving with the drowsiness moni-
tor
Connection and disconnection
Depending on the country, the drowsiness
monitor is activated whenever the vehicle's
drive system is activated.
If desired, you can switch o the drowsiness
monitor manually in the infotainment system:
1. Open the Assistance systems menu.
2. Switch the drowsiness monitor on or
o in the corresponding submenu
›››page40..
Sensitivity adjustment
You can manually adjust the sensitivity of the
drowsiness monitor and therefore inuence
how quickly the system reacts to your driving
behaviour.
In the infotainment system:
1.
Open the Assistance systems menu.
2. Open the Drowsiness monitor.
3. Select the sensitivity in the Sensitivitysub-
menu›››page40.
Concealing messages via the multi-function
steering wheel
1. Press the button on the multifunction
steering wheel.
Drowsiness monitor warning levels
If the system detects that the driver is tired,
it indicates this visually on the instrument clus-
ter display by means of a control or warning
lamp in combination with a supplementary text
message and an audible warning. The warning
is issued at three levels.
Drowsiness monitor warning - Level 1
The system has detected that the driver is
becoming tired. An audio signal sounds. A
white control lamp and a text message are
shown on the instrument cluster screen.
Consider taking a break.
Drowsiness monitor warning - Level 2
The system has detected that the driver
is becoming increasingly tired. An audio
signal sounds. A red warning lamp appears
is shown on the instrument cluster screen
together with a text message. Consider
taking a break soon.
Drowsiness monitor warning - Level 3
Serious risk identied. An audio signal
sounds. A red warning lamp appears is
shown on the instrument cluster screen
together with a text message. Serious traf-
c risk. Stop driving as soon as possible
and proceed urgently to the nearest place
where you can take a break.
Time-related information
The drowsiness monitor detects that the
driver has been driving for 4.5 hours with-
out a break and without any recognised
fatigue. A white control lamp and a text
message are shown on the instrument
cluster screen. Consider taking a break.
Troubleshooting
Availability of the drowsiness monitor is
restricted
An audio signal sounds. A yellow control light
appears along with a text message on the in-
strument cluster screen. The availability of the
drowsiness monitor is restricted.
●
Fault or malfunction. Deactivate and reacti-
vate the vehicle drive system.
●
If the problem persists, visit a duly qualied
workshop. CUPRA recommends that you visit
an oicial dealer.