Cupra TERRAMAR 2024 - Warning and Information Messages; Time and Date; Service Menu

Driver information
25
Instrument panel
This does not present any problem as long as
the warning lamps or ›››page361 do
not appear on the display.
Warning and information messages
The system runs a check on certain com-
ponents and functions when the ignition is
switched on and while the vehicle is moving.
Faults are displayed on the instrument clus-
ter display as red and yellow warning symbols
›››page11 accompanied by messages and,
depending on the case, even an audible warn-
ing. The representation of the messages and
symbols may vary depending on the version of
the instrument panel.
Existing faults can also be checked man-
ually. To do this, open the Vehicle status
›››page34 menu.
Priority 1 warning (in red)
The symbol lights up or ashes (in part ac-
companied by audible warnings). Stop driv-
ing! Danger! Check the fault and eliminate
the cause. If necessary, seek professional as-
sistance.
Priority 2 warning (in yellow)
The symbol lights up or ashes (in part accom-
panied by audible warnings). Operating faults
or the lack of operating uids can cause dam-
age to the vehicle or a fault. Check the faulty
function as soon as possible. If necessary, seek
professional assistance.
Reference to information in the own-
er's manual
Further information on any warnings can be
found in the owner's manual.
Information message
It provides information about processes in the
vehicle.
Accessing warnings and information
Existing faults can also be checked in the info-
tainment system:
●
Press > Vehicle > Vehicle status
›››page39.
Time and date
Setting the time on the infotainment system
●
Press > Settings ›››page35.
●
Select the menu option Date and time.
Service Menu
In the Service menu various settings can be
adjusted depending on the features.
Open the Service menu
●
While in Classic View, go to the circle on the
left and select the odometer, then press the
button on the multifunction steering wheel
for around 5 seconds and then release it.
●
Next, the Conguration list menu is dis-
played, where you can choose between the
Service menu or the View selection from
where the instrument cluster views can be
switched on and o.
Restart the service interval display
Select the Service menu and follow the in-
structions on the screen of the instrument
panel.
Restart the oil service
Select the Reset Oil service menu and follow
the instructions on the instrument panel dis-
play.
Identifying letters on engine (LDM)
Select the menu Engine code. The identifying
letters of the engine will be shown on the in-
strument cluster display at the bottom left.
Next Service
This species when the next workshop inspec-
tion is scheduled.