EasyManua.ls Logo

Cupra TERRAMAR 2024 - General Instructions for Use; Operating Indications; Home Screen

Cupra TERRAMAR 2024
430 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
284
Infotainment system
General instructions for
use
Operating indications
The infotainment needs a few seconds for
the complete start-up of the system and dur-
ing that time it does not react to inputs. Only
the image of the rear view camera system can
be displayed during system start-up.
The display of all indications and the execu-
tion of functions only takes place once the in-
fotainment system has nished booting. The
duration of the system booting depends on
the number of infotainment functions and may
take longer than normal in the event of very
high or very low temperatures.
When using the infotainment system and
corresponding accessories, e.g., headphones,
bear in mind country-specic regulations and
legal provisions.
Some functions of the infotainment system
require an active CUPRA CONNECT user ac-
count and an Internet connection for the vehi-
cle. The data transmission must not be limited
to perform the functions.
To use the infotainment system, simply lightly
press a button or touch the screen.
For the correct operation of the infotain-
ment system it is important that it is switched
on and that, if necessary, the time and date of
the vehicle are set correctly.
If a function button is missing on the screen,
it is not a device defect, but corresponds to the
specic equipment of the country or version.
Some infotainment functions can only be se-
lected when the vehicle is at a standstill. In
some countries the parking lock must also be
enabled (button P ) or the selector control
must be in the neutral position N. This is not
a malfunction, but is due to compliance with
legislation.
Restrictions on the use of devices using
Bluetooth® technology may apply in some
countries. For further information, contact the
local authorities.
If you disconnect the 12-volt battery, turn on
the ignition before restarting the infotainment
system.
If the setup is changed, this may change the
display on the screen and in some cases, the
infotainment system may behave in a manner
dierent to that described in this instruction
manual.
In some countries, the infotainment system
automatically shuts o when the engine is
switched o and the vehicle's 12-volt battery
charge level is low.
Ensure that any repairs or modications that
need to be carried out on the infotainment
system are carried out by a specialised work-
shop. To do so, CUPRA recommends going to a
specialised CUPRA dealer or any SEAT dealer-
ship.
Using a mobile phone device inside the vehi-
cle may cause noise in the speakers.
On vehicles with park assist, the audio
source volume is automatically lowered when
reverse gear is selected. The volume reduction
can be adjusted.
Information about the included software and
the license conditions can be found in Set-
tings > Information > Copyright.
When selling or lending the vehicle, make
sure that all saved data, les and settings have
been deleted and, if necessary, external audio
sources and data media have been removed.
Note
You will nd more information and tips for
using the infotainment system in the Help
menu.
Home screen
If an icon is missing on the screen, it is not a
device defect, but corresponds to the specic
equipment of the country or version.
The following menus can be included as an
icon:
Main menus
Vehicle ›››page40
Navigation ›››page299

Table of Contents

Related product manuals