Cupra TERRAMAR 2024 - Troubleshooting

Parking and manoeuvring
249
Reverse Assist (Rear View Camera)
1
2
3
4
Angle parking
Fig.160 Display on the infotainment
system screen: parking with the reverse
assistant.
Key to ›››Fig.160:
Find a parking space
Go to the selected parking space
Centre the vehicle inside the parking
space
Road
Parking space
Side boundary of the parking space
Rear boundary of the parking space
Parking
●
In the infotainment system select > Driver
assist > Park assist before passing in front of
the selected parking space.
●
With reverse assist connected and in opera-
tion, press the function button .
●
Stop the vehicle in front of the parking space
›››Fig.160
2
.
●
Reverse while turning the steering wheel so
that the yellow lines enter the parking space.
The green and yellow lines must match the
side boundary lines
3
.
●
Stop the vehicle when the red line has
reached the rear boundary
4
.
Troubleshooting
The system behaves dierently than expec-
ted
There can be several causes:
●
The camera is dirty ›››page392. In addi-
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
●
The system requirements must be met
›››page247.
●
The camera is covered with water.
●
The factory-tted towing bracket must
not be electrically connected to a trailer
›››page320.
●
The vehicle has some type of damage in the
camera area, e.g. due to a parking impact.
●
The eld of view of the camera is blocked by
an accessory, e.g. a bicycle carrier system.
●
Changes have been made to the paint in the
camera area, or structural modications have
been made to a component such as the run-
ning gear.
Camera with no visibility, fault message, the
system disconnects
●
Clean the camera or remove possible adhe-
sives or accessories from it ›››page392.
●
Check for visible damage.
Possible solution
●
Temporarily disconnect the system.
●
Check if one of the causes indicated above
has occurred.
●
Once the source of the problem has been
eliminated, the system may be reconnected.
●
If the system still behaves unpredictably,
have it checked by a specialised workshop.