Cupra TERRAMAR 2024 - Front Towline Anchorage

Miscellaneous situations
343
Towing the vehicle
●
Make sure the tow cable is always taut.
●
Disengage the gear or place the gear selec-
tor in the Nposition.
WARNING
Never attach the tow rope or tow bar to axle
or running gear components. They could be
damaged, resulting in an accident and seri-
ous injury.
●
Seek specialist assistance and, if applica-
ble, have the vehicle transported on a tow
truck.
NOTICE
The vehicle can only be towed if the state of
charge of the 12-volt battery is suicient to
disengage the electronic parking brake and
the steering column lock. If the vehicle has
no power supply or there is an electric sys-
tem fault, the engine must be jump-started
to release the electronic parking brake and
deactivate the electronic lock of the steering
column.
Front towline anchorage
Fig.211 Front bumper on right: remove the
lid.
Fig.212 Right side of the front bumper:
towline anchorage screwed in.
The housing of the removable towline anchor-
age is on the right side of the front bumper
underneath a cover ›››Fig.211.
The towing eye should always be kept in the
vehicle.
Bear in mind the instructions for towing
›››page342.
Fitting the towline anchorage
●
Remove the towing eye from the vehicle tool
kit in the luggage compartment ›››page336.
●
Remove the cover by pressing down on its
base and leave it hanging from the vehicle
›››Fig.211.
●
Screw the towing eye in the housing by
turning it to the maximum anticlockwise
›››Fig.212 , ››› . Use a suitable object
that can completely and securely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye clock-
wise with a suitable object.
●
Replace the cover and push it in until it clicks
into place.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along with
the other vehicle tools.
NOTICE
The towing eye must always be completely
and rmly tightened. Otherwise, it could
jump out of the housing during towing.