1)
Only if tted with the PreCrash System.
●
in the event of sudden brakes
●
in the event of oversteering or understeering
●
in the event of minor collisions
Belt force limiter
Depending on the equipment and the country
in question, in the event of an accident, the
seat belt force limiter reduces the force the
seat belt exerts on the body.
Note
●
After certain driving situations, the reversi-
ble belt tensioners may be left permanently
tensioned
1)
. In this case, to loosen the belt, it
must be removed manually while the vehicle
is stationary and then replaced correctly.
●
The relevant safety requirements must be
observed if the vehicle or any components
of the system are to be scrapped. Specialised
workshops are aware of these requirements.
Maintenance and disposal of seat
belt tensioners
The belt tensioners are components of the
seat belts that are installed in the seats of your
vehicle. If you work on the belt tensioners or
remove and install parts of the system when
performing other repair work, the seat belt
may be damaged. The consequence may be
that, in the event of an accident, the belt ten-
sioners function incorrectly or may not func-
tion at all.
So that the eectiveness of the seat belt ten-
sioner is not reduced and that removed parts
do not cause any injuries or environmental
pollution, regulations, which are known to the
specialised workshops, must be observed.
WARNING
Improper handling and home repairs to seat
belts, automatic retractors and belt tension-
ers may increase the risk of serious or fa-
tal injuries. The tensioners may not activate,
even though they should, or they may acti-
vate unexpectedly.
●
Never repair, adjust, or disassemble and re-
assemble seat belt components or tension-
ers. Always have this work carried out by a
specialist workshop.
●
Seat belts, tensioners and their automatic
retractors cannot be repaired and have to be
replaced.
For the sake of the environment
Airbag modules and belt tensioners may con-
tain perchlorate.
Observe the legal requirements for their dis-
posal.
PreCrash system
How it works
The PreCrash system is an assistance system
that actives a series of measures to protect
the occupants of the vehicles in potentially
risky situations, but which cannot prevent a
collision.
It only works completely if no special driving
prole is selected and if there are no operating
anomalies.
At the start of each journey and depending on
the time of use and the speed of the vehicle,
the seatbelt is automatically pretensioned in
order to reduce slack in the driver's and front
passenger's seatbelts, provided they are buck-
led.
Basic features
Depending on the legal provisions of the coun-
try and the features of the vehicle, in critical
situations (e.g. in certain cases of emergency
braking or loss of control of the vehicle by the
driver) the following functions can be activated
separately or at the same time when the vehi-
cle is travelling faster than approximately 30
km/h (20 mph).