Cupra TERRAMAR 2024 - Net Partition; Using the Net Partition

Storing objects
315
Net partition
Variable oor in the tilted position
Fig.187 Variable luggage compartment
oor: tilted position.
When the variable oor is tilted you can access
the spare wheel or anti-puncture kit area.
●
Lift the variable oor in the high position us-
ing handle ›››Fig.185
1
, pull it up and push
it towards the backrest of the rear seats until it
folds along the hinge line and the movable part
of the oor is resting on itself.
●
Rest the oor on its housings ›››Fig.187
(arrows).
WARNING
●
Always secure objects, even when the lug-
gage compartment oor is properly lifted.
●
Only objects that do not protrude more
than 2/3 the height of the oor may be car-
ried between the rear seat and the raised
luggage compartment oor.
●
Only objects that do not weigh than ap-
proximately 7.5 kg may be carried between
the rear seat and the raised luggage com-
partment oor.
NOTICE
●
The maximum weight that can be loaded
on the luggage compartment variable oor in
the top position is 100 kg.
●
Do not let the luggage compartment oor
fall when closing it. Always carefully guide
it downwards in a controlled manner. Other-
wise, the lining and the oor of the luggage
compartment could be damaged.
Net partition
Using the net partition
Fig.188 Net partition tted.
The purpose of the net partition is to prevent
the items in the boot from moving into the
cabin, e.g. in the event of sudden braking.
Fitting the net partition
The partition net can be tted behind the rear
seat or, depending on the features, behind the
front seats with the second row of seats low-
ered.
●
If required, remove the rear shelf
›››page313.
●
Hook the net partition to the left-hand side
roof housing ›››Fig.188
A
. Be sure to pull
the cross rod down past the upper position.