EasyManua.ls Logo

Cupra TERRAMAR 2024 - Connecting and Disconnecting

Cupra TERRAMAR 2024
430 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
248
Parking and manoeuvring
In the following situations, objects or other
vehicles appear to be further away or closer
than they actually are. Pay special attention:
If moving from a at surface to a slope
and vice-versa.
If the vehicle is heavily loaded.
When the vehicle approaches objects
that are not on the ground surface or that
protrude from it. These objects may be
outside the camera angle when reversing.
Note
It is important to take great care and pay
special attention if the driver is not familiar
with the system.
The reverse assist reference lines disap-
pear when the rear lid is open.
Connecting and disconnecting
Connect the reverse assist
With the ignition switched on, select reverse
gear.
OR: in the infotainment system select >
Driver assist > Park assist.
Disconnect the reverse assist
Drive forward at a speed of at least 15 km/h
(9 mph).
Shown on the display
The system’s functions and representations
may vary depending on the equipment.
The assistant's image view changes when the
factory-tted tow hitch is electronically con-
nected to a trailer ›››page320.
Reverse assist functions and symbols
When the reverse assist is connected, you can
make adjustments using the function buttons.
Some adjustments are equipment-dependent.
Exit the current display
Switch to angle parking ›››page249
Switch to the trailer hitching assistance
function
Switch to cross traic
Adjust the display: brightness, contrast
and colour.
Switch to park assist ›››page230
Display/hide the Park Assist view
Guide lines
Green horizontal lines: extension of the vehi-
cle.
Yellow lines:
vehicle path depending on the
steering angle.
Assistance function for hitching a trailer
On vehicles with a factory-tted towing device,
this function can be used to move the vehicle
close to a tow bar.
Auxiliary lines are shown in the infotainment
system.
Green lines: distance to the trailer hitch. The
distance between the lines is approx. 0.30 m
Yellow line: pre-calculated direction of the
trailer hitch depending on how the steering
wheel is turned.
Cross traic
This view helps to monitor traic behind the
vehicle and can be used, for example, when
exiting garages or narrow exits.

Table of Contents

Related product manuals