Cupra TERRAMAR 2024 - Troubleshooting

Fuel and exhaust gas cleaning
335
Engine management and emissions control system
This procedure involves an autonomous par-
ticulate lter cleaning process and may take
some time.
If the warning lamp does not turn o, go im-
mediately to a specialised workshop to repair
the fault.
WARNING
Always adjust your speed to suit the weather
conditions, roads, braking distance and traf-
c if the particulate lter is in its regenera-
tion phase. Route recommendations should
never make you disregard each country's
specic traic regulations.
Note
If during the particulate lter regeneration
process you also get a fuel reserve warning ,
the process may be interrupted. Refuel and
continue with the particulate lter regenera-
tion process.
NOTICE
●
When the exhaust system detects that the
particulate lter is close to saturation, the
self-cleaning function of this system recom-
mends optimal driving for this function.
●
Due to the high temperatures caused by
the regeneration of the particulate lter, it is
possible that the radiator fan will activate af-
ter stopping the engine, even it its operating
temperature has not been reached.
●
Noise, smells and high idle speeds can oc-
cur during regeneration.
●
Always use the correct engine oil and the
correct fuel to make sure the useful life of
the particulate lter is not aected. Also
avoid making short trips all the time.
Troubleshooting
Fault in the emission control system.
The indicator lamp lights up yellow.
Reduce speed and drive carefully to the near-
est specialised workshop to have the engine
checked.
Combustion failures that can damage
the catalytic converter.
The control lamp ashes yellow.
Reduce speed and drive carefully to the near-
est specialised workshop to have the engine
checked.
Particulate lter blocked
The indicator lamp lights up yellow
›››page334..
Petrol engine management fault
The indicator lamp lights up yellow.
Have the engine checked as soon as possible
by a specialised workshop.
When the ignition is switched on, the
(Electronic Power Control) lamp lights up and
should go o once the engine has started.
NOTICE
While the indicator lamps , or
are on, there might be faults in the engine,
fuel consumption may go up and the engine
might lose power.