EasyManua.ls Logo

Cupra TERRAMAR 2024 - Interior Mirror; Adjusting the Exterior Mirrors

Cupra TERRAMAR 2024
430 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Visibility
141
Mirrors
/
If the electrolytic uid comes into contact
with your eyes or skin, immediately rinse the
aected area with plenty of water for at least
15 minutes and seek medical advice.
If the uid comes into contact with foot-
wear or clothing, rinse immediately with
plenty of water for at least 15 minutes. Clean
thoroughly before using the footwear or
clothing in question again.
If the electrolytic uid is swallowed, imme-
diately rinse the mouth with plenty of water
for at least 15 minutes. Do not induce vomit-
ing unless advised by a doctor. Immediately
seek medical attention.
NOTICE
Electrolyte uid may leak if the automatic
anti-dazzle mirror is broken. This liquid at-
tacks plastic surfaces. Therefore, it should
be cleaned as fast as possible with a damp
sponge or similar.
Interior mirror
Rear view mirror with automatic anti-dazzle
function
When the ignition is switched on, the sensors
in the mirror measure the light falling on it from
behind and in front.
The interior mirror automatically darkens
based on the measured values.
If the light falling onto the sensors is blocked or
interrupted, e.g. by a sunshade blind or hang-
ing objects, the automatic anti-dazzle interior
mirror does not work or does not work prop-
erly. Similarly, the use of portable navigation
devices attached to the windscreen or close to
the automatic anti-dazzle interior mirror can
aect the operation of the sensors ››› .
The automatic anti-dazzle function is deacti-
vated in certain situations, e.g. when reverse
gear is engaged.
WARNING
Light from screens of portable navigation
devices can cause malfunctions of the au-
tomatic anti-dazzle interior mirror and may
cause serious accidents and injuries.
Abnormal operation of the automatic anti-
dazzle function may result in it being impos-
sible to use the interior mirror to precisely
calculate the distance to vehicles driving be-
hind, or to other objects.
Adjusting the exterior mirrors
Fig.107 Driver’s door detail: exterior
mirror control.
Turn the control to the corresponding posi-
tion.
By moving the control to the desired po-
sition, adjust the rear view mirrors on the
left side ( ) and on the right side ( ) in the
desired direction.
Depending on the equipment tted on
the vehicle, the mirrors may be heated
according to the outside temperature.
Fold the mirrors ››› .
The exterior mirror cannot be adjusted
and all functions are deactivated.

Table of Contents

Related product manuals