DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
163
To display summarized information about the Captive Portal’s configuration when the Captive
Portal is disabled:
DWS-3160-24PC:admin#show captive_portal
Command: show captive_portal
Administrative Mode : Disable
Operational Status : Disabled
Disable Reason : Administrator Disabled
CP IP Address : 0.0.0.0
To display the reporting status of all Captive Portal instances in the System:
DWS-3160-24PC:admin#show captive_portal status
Command: show captive_portal status
Additional HTTP Port : 100
Additional HTTP Secure Port : 0
Peer Switch Statistics Reporting Interval : 0
Authentication Timeout : 600
Supported Captive Portals : 10
Configured Captive Portals : 1
Active Captive Portals : 0
Local Supported Users : 128
Configured Local Users : 0
System Supported Users : 1024
Authenticated Users : 0
To display which Captive Portal SNMP traps are enabled:
DWS-3160-24PC:admin#show captive_portal trap
Command: show captive_portal trap
Client Authentication Failure Traps : Enable
Client Connection Traps : Enable
Client Database Full Traps : Enable
Client Disconnection Traps : Enable
In the above examples the following display parameters can be noticed:
Administrative Mode - Displays whether the CP is enabled or not.
Operational Status - Indicates whether the CP operational status is enabled or disabled.
Disable Reason - If the CP is disabled, this field displays the reason, which can be None,
Administrator Disabled, IP Address Not Configured, No IP Routing Interface or Routing
Captive Portal IP Address - Displays the IP address that the Captive Portal feature uses.
To Next Page
Loading...
