D-Link DWS-3160-24TC - Page 237

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
233
<string 32> - Enter the MEP name used here. This name can be up to 32 characters long.
md – (Optional) Specifies the maintenance domain name.
<string 22> - Enter the maintenance domain name her. This name can be up to 22 characters
long.
md_index – (Optional) Specifies the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
between 1 and 4294967295.
ma – (Optional) Specifies the maintenance association name.
<string 22> - Enter the maintenance association name her. This name can be up to 22
characters long.
ma_index – (Optional) Specifies the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value must
between 1 and 4294967295.
mepid – (Optional) Specifies the MEP ID used.
<int 1-8191> - Enter the MEP ID used here. This value must be between 1 and 8191.
remote_mepid - Specifies the Remote MEP ID used.
<int 1-8191> - Enter the remote MEP ID used here. This value must be between 1 and 8191.
Restrictions
None.
Example
To display the CFM Remote MEP information:
DWS-3160-24PC:admin# show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID : 2
MAC Address : 00-11-22-33-44-02
Status : OK
RDI : Yes
Port State : Blocked
Interface Status : Down
Last CCM Serial Number : 1000
Sender Chassis ID : 00-11-22-33-44-00
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time : 2008-01-01 12:00:00
DWS-3160-24PC:admin#
19-25 show cfm pkt_cnt
Description
This command is used to display the CFM packet’s RX/TX counters.
Format
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}