DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
260
DWS-3160-24PC:admin#debug show status
Command: debug show status
Debug Global State : Disabled
MSTP : Disabled
IMPB : Disabled
VRRP : Disabled
ERPS : Disabled
WLAN : Disabled
CP : Disabled
DWS-3160-24PC:admin#
22-9 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
all - Print out all debug messages.
state - This parameter configures the IMPB debug state to be enabled or disabled.
enable - Specifies that the state will be enabled.
disable - Specifies that the state will be disabled.
Restrictions
Only Administrators can issue this command.
Example
To print out all debug IMPB messages:
DWS-3160-24PC:admin# debug address_binding all state enable
Command: debug address_binding all state enable
Success.
To Next Page
Loading...
