D-Link DWS-3160-24TC - Page 304

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
300
27-6 config erps log
Description
This command is used to configure the log state of ERPS events.
Format
config erps log [enable | disable]
Parameters
log - Specifies to enable or disable the ERPS log state.
enable - Enter enable to enable the log state.
disable
- Enter disable to disable the log state. The default value is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the ERPS log state:
DWS-3160-24PC:admin# config erps log enable
Command: config erps log enable
Success.
DWS-3160-24PC:admin#
27-7 config erps trap
Description
This command is used to configure trap state of ERPS events.
Format
config erps trap [enable | disable]
Parameters
trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.