D-Link DWS-3160-24TC - Page 344

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
340
The VLAN must be created first before a static group can be created.
Format
create igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
Parameters
vlan - Specifies the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specifies the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID here.
<ipaddr> - Specifies the multicast group IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create an IGMP snooping static group for VLAN 1, group 239.1.1.1:
DWS-3160-24PC:admin#create igmp_snooping static_group vlanid 2 239.1.1.1
Command: create igmp_snooping static_group vlanid 2 239.1.1.1
Success.
DWS-3160-24PC:admin#
32-9 delete igmp_snooping static_group
Description
This command is used to delete an IGMP snooping multicast static group. The deletion of an
IGMP snooping static group will not affect the IGMP snooping dynamic member ports for a group.
Format
delete igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
Parameters
vlan - Specifies the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specifies the ID of the VLAN on which the router port resides.
<vlanid_list>
- Enter the VLAN ID list here.
<ipaddr> - Specifies the multicast group IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.