D-Link DWS-3160-24TC - Page 431

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
427
42-5 config mac_based_access_control guest_vlan
Description
This command is used to assign a specific port list to the MAC-based Access Control guest VLAN.
Ports that are not contained in port list will be removed from the MAC-based Access Control guest
VLAN.
Format
config mac_based_access_control guest_vlan ports <portlist>
Parameters
ports - Specifies MAC-based Access Control guest VLAN membership.
<portlist> - Enter the list of port used for this configuration here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the MAC-based Access Control guest VLAN membership:
DWS-3160-24PC:admin#config mac_based_access_control guest_vlan ports 11
Command: config mac_based_access_control guest_vlan ports 11
Success.
DWS-3160-24PC:admin#
42-6 config mac_based_access_control ports
Description
This command is used to configure the MAC-based Access Control port’s setting.
When the MAC-based Access Control function is enabled for a port and the port is not a MAC-
based Access Control guest VLAN member, the user who is attached to this port will not be
forwarded unless the user passes the authentication.
• A user that does not pass the authentication will not be serviced by the Switch.
• If the user passes the authentication, the user will be able to forward traffic operated under
the assigned VLAN.
When the MAC-based Access Control function is enabled for a port, and the port is a MAC-based
Access Control guest VLAN member, the port(s) will be removed from the original VLAN(s)
member ports, and added to MAC-based Access Control guest VLAN member ports.
• Before the authentication process starts, the user is able to forward traffic under the guest
VLAN.
• After the authentication process, the user will be able to access the assigned VLAN.