D-Link DWS-3160-24TC - Page 555

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
551
<value 64-1024000> - Enter the transmitting data rate here. This value must be between 64
and 1024000 Kbits/sec.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the port bandwidth:
DWS-3160-24PC:admin#config bandwidth_control 1-10 tx_rate 100
Command: config bandwidth_control 1-10 tx_rate 100
Granularity: RX: 64, TX: 64. Actual Rate: TX: 64.
Success.
DWS-3160-24PC:admin#
59-2 show bandwidth_control
Description
This command is used to display the port bandwidth configurations. The bandwidth can also be
assigned by the RADIUS server through the authentication process. If RADIUS server has
assigned the bandwidth, then the RADIUS-assigned bandwidth will be the effective bandwidth.
The authentication with the RADIUS sever can be per port or per user. For per-user authentication,
there may be multiple bandwidth control values assigned when there are multiple users attached
to this specific port. In this case, the largest assigned bandwidth value will be applied to the
effective bandwidth for this specific port.
NOTE: Only devices that support MAC-based VLAN can provide per user
authentication.
Format
show bandwidth_control {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
If no parameter specified, system will display all ports bandwidth configurations.
Restrictions
None.
Example
To display port bandwidth control table: