D-Link DWS-3160-24TC - Page 630

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
626
66-31 config snmp coldstart_traps
Description
This command is used to configure the trap for cold start event.
Format
config snmp coldstart_traps [enable | disable]
Parameters
enable - Enable the trap of the cold start event. The default state is enabled.
disable - Disable the trap of the cold start event.
Restrictions
Only Administrators can issue this command.
Example
To configure the trap for cold start event:
DWS-3160-24PC:admin# config snmp coldstart_traps enable
Command: config snmp coldstart_traps enable
Success.
DWS-3160-24PC:admin#
66-32 config snmp warmstart_traps
Description
This command is used to configure the trap state for warm start event.
Format
config snmp warmstart_traps [enable | disable]
Parameters
enable - Enable the trap of the warm start event. The default state is enabled.
disable - Disable the trap of the warm start event.
Restrictions
Only Administrators can issue this command.