D-Link DWS-3160-24TC - Page 732

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
728
DWS-3160-24PC:admin#config wireless ap_profile 1 radio 1 wmm enable
Command: config wireless ap_profile 1 radio 1 wmm enable
Success.
DWS-3160-24PC:admin#
82-5 show wireless ap_profile
Description
This command is used to display the AP Profile configuration parameters. If no parameter is
specified, a summary of the configured AP Profiles will be displayed. The detailed configuration
includes radio, VAP, and QoS configuration.
Format
show wireless ap_profile {<int 1-16> {radio {<int 1-2> {[auto_eligible | mcs_index | qos
{[ap_edca | station_edca]} | rates {[basic | supported]} | vap {<int 0-15>}]}}}}
Parameters
<int 1-16> - (Optional) Enter the configured AP profiles ID here. If you do not enter any command
parameters, a summary of all AP profiles is displayed.
radio - (Optional) Specifies the radio configuration for an AP profile. When you enter the required
profile ID, a summary view of the radio configuration is displayed. If you enter a radio index,
the radio configuration detail is displayed.
<int 1-2> - Enter the radio configuration for an AP profile here. This value must be between 1
and 2.
auto_eligible - (Optional) Specifies to display supported channels on the radio that are eligible
for auto-channel selection.
mcs_index - (Optional) Specifies to displays MCS information.
qos - (Optional) Specifies to display the configured values for a radio interface per QoS Queue
(AP-EDCA and Station-EDCA).
ap_edca - Specifies to display the configured values for a radio interface per AP-EDCA QoS
Queue.
station_edca - Specifies to display the configured values for a radio interface per Station-
EDCA QoS Queue.
rates - (Optional) Specifies to display the list of supported and basic client data rates for the
radio.
basic - Specifies to display the list of basic client data rates for the radio.
supported - Specifies to display the list of supported data rates for the radio.
vap - (Optional) Specifies that when you enter the required VAP ID, a summary view of the VAP
configuration will be displayed. If you enter a VAP index, the VAP configuration detail is
displayed.
<int 0-15> - Enter the required VAP ID value used here. This value must be between 0 and
15.
Restrictions
None.
Example
To display a summary of AP Profiles: