D-Link DWS-3160-24TC - Page 815

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
811
Format
config wireless certificate_generate
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To initiate the regeneration of the X.509 certificate:
DWS-3160-24PC:admin#config wireless certificate_generate
Command: config wireless certificate_generate
Success.
DWS-3160-24PC:admin#
91-4 config wireless certificate_request peer
Description
This command is used to request a X.509 certificate from the cluster controller. The X.509 mutual
certificate exchange is the only mechanism for peer Switches to authenticate with each other
because Switches do not support a pass-phrase authentication. The X.509 certificate is
automatically generated by the Switch and does not communicate with any trusted certificate
authority.
Format
config wireless certificate_request peer <ipaddr> start
Parameters
<ipaddr> - Enter the IP address, of the wireless Switch, from which this Switch requests an
X.509 certificate.
start - Specifies to start the request.
Restrictions
Only Administrators can issue this command.
Example
To start the wireless Switch certificate request: