D-Link DWS-3160-24TC - Page 911

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
907
Restrictions
None.
Example
To display the configured global wireless Switch’s status parameters.
DWS-3160-24PC:admin#show wireless status
Command: show wireless status
Total Access Points : 0
Managed Access Points : 0
Connection Failed Access Points : 0
Discovered Access Points : 0
Maximum Managed APs in Peer Group : 48
Rogue AP Mitigation Count : 0
Rogue AP Mitigation Limit : 16
Total Clients : 0
Authenticated Clients : 0
Maximum Associated Clients : 2048
Detected Clients : 7
Maximum Detected Clients : 4096
Peer Switches : 0
Unknown Access Points : 8
Rogue Access Points : 2
Standalone Access Points : 0
AP Provisioning Count : 2
Maximum AP Provisioning Entries : 96
Distributed Tunnel Clients : 0
WLAN Utilization : 0 %
Maximum Pre-authentication History Entries : 500
Total Pre-authentication History Entries : 0
Maximum Roam History Entries : 500
Total Roam History Entries : 0
DWS-3160-24PC:admin#
95-46 show wireless switch
Description
This command is used to display the wireless Switch’s status information.
Format
show wireless switch [<ipaddr> | local] {[statistics | client]}
Parameters
<ipaddr> - Enter the IP address of the wireless Switch, in the wireless system, here.
local - Specifies that local wireless Switch in the wireless system.
statistics - (Optional) Specifies that current wireless Switch statistics will be displayed.
client - (Optional) Specifies to display summarized data for all AP associated client’s