Web Operations 175
“Port” corresponds to your HTTPS port. If the default value is 443, do not enter “: Port”, and
just enter “https://xx.xx.xx.xx” to visit.
5.3.2.2 Configuring MAC Acquisition
5.3.2.2.1 Configuring MAC Acquisition Parameters
After MAC acquisition function is enabled, the system automatically collects the MAC
addresses of nearby devices. When the Device is accessed to the Platform, the system reports
the MAC information to the Platform by the configured interval.
Select SETUP > NETWORK > WIFI. Step 1
The WIFI interface is displayed.
In the Working Mode Collection list, select Mac. Step 2
The Mac setting interface is displayed. See Figure 5-62.
Mac setting Figure 5-62
In the Upload Interval box, enter the interval. Step 3
Configure this parameter when the Device is accessed to Platform.
Click Save. Step 4
5.3.2.2.2 Viewing MAC Information
After the MAC information has been collected, you can view, search, back up, and delete MAC
information.
Select INFO > INFO > Mac Info. Step 1
The Mac Info interface is displayed.
Enter the start time and end time. Step 2
Click Search. Step 3
The MAC information satisfying the searching conditions is displayed. See Figure 5-63.
Mac information Figure 5-63
To Next Page
Loading...
Need help?
General