Web Operations 186
The available Wi-Fi networks list including the information such as connection
mode, authorization mode, and signal intensity.
2) Double-click the Wi-Fi that you want to connect, enter the password, and then click
Save.
Manual add
1) Click Static Setting.
The WIFI setting interface is displayed. See Figure 5-71.
WIFI setting Figure 5-71
2) Enter SSID, select priority level and verification type, set IP address, subnet mask,
and gateway.
If you select the DHCP check box, after the connection succeeded, the system will
automatically obtain the IP address, subnet mask, and gateway.
3) Click Save.
Click Save. Step 4
Click Refresh to refresh the connection status.
After connection is succeeded, you can view the current hotspot, IP address, subnet
mask, and gateway in the WIFI Working Info area.
5.3.2.7.3 Configuring Wi-Fi Hotspot
The Device can work as a hotspot to share the network connection to other terminals. The
terminals that are connected to the hotspot can login the Device through IP address
(192.168.2.108). After login, you can preview the video on the Device.
Select SETUP > NETWORK > WIFI. Step 1
The WIFI interface is displayed.
In the Working Mode Selection list, select Ap. Step 2
The Ap interface is displayed. See Figure 5-72.
To Next Page
Loading...
