Local Configurations 66
4.3.1.2.3 Configuring Snapshot Settings
You can configure the snapshot type, size, quantity, and image quality.
Select Main Menu > SETTING > ENCODE. Step 1
The ENCODE interface is displayed.
Click Snapshot. Step 2
The SNAPSHOT interface is displayed, see Figure 4-51.
Snapshot settings Figure 4-51
Configure the parameters. For details, see Table 4-22. Step 3
Table 4-22 Snapshot settings description
In the Mode list, select Regular or Trigger.
Regular: Take a snapshot within the configured time period.
Trigger: Take a snapshot when there is a video detection event occurs.
Select a resolution for the captured image.
Configures the image quality by six levels. The higher the level, the better the
image will become.
Configure the snapshot frequency. The maximum value you can set is 3600
seconds as an interval between two snapshots.
Configure snapshot schedule. Step 4
The auto snapshot function is enabled. For details, see "4.1.7 Configuring Record
Settings."
1) Click Setup.
The Time Period interface is displayed. See Figure 4-52.
To Next Page
Loading...
