Dahua MCVR6204 - Page 82

Local Configurations 71
Click NETWORK SETTING. Step 2
The NETWORK SETTING interface is displayed.
Configure email settings.
Step 3
1) Double-click EMAIL.
The EMAIL interface is displayed. See Figure 4-56.
EMAIL settings Figure 4-56
2) Configure the parameters. For details, see Table 4-25.
Table 4-25 EMAIL settings parameter description
Parameter
Description
SMTP server
Configure the address of Simple Mail Transfer Protocol. For details, see
Table 4-26.
Port
Enter the port value of SMTP server. For details, see Table 4-26.
Username
Enter the user name and password of SMTP server. For details, see Table
4-26.
Password
Sender
Enter the sender’s email address.
Receiver
Enter the email address of mail receiver. You can enter maximum three
email addresses separated by colon.
Subject
Supports Chinese, English, and Arabic numerals. You can enter maximum
63 characters.
Encrypt
In the Encrypt list, select an encryption type from NONE, SSL, and TLS.
For details, see Table 4-26.
Event Interval
This is the interval that the system sends an email for the same type of
alarm event, which means, the system does not send an email upon any
alarm event. This setting helps to avoid the large amount of emails caused
by frequent alarm events.
The value ranges from 0 seconds to 3600 seconds. 0 means that there is
no interval.
Health Enable
The system can send a test email to check the connection.