Local Configurations 76
6) Tap > Device Manager.
The Device Manager interface is displayed. See Figure 4-59.
Device manager Figure 4-59
7) Click , follow the onscreen instructions to initialize device if needed, and then
add the device by wired connection or wirelessly by scanning the QR code.
After the Device is added, click Start Live Preview to see the live view interface of Step 3
Device.
4.3.2.5 Configuring Switch Settings
After IP address for Switch is configured, when connecting IP camera to PoE port of Device, the
Switch will automatically allocate IP address to the IP camera, and then the Device can get
connected to this IP camera.
This function is supported only by the Device with PoE port.
The Switch cannot be connected to PoE port; otherwise the connection will fail.
By default, the Switch Settings check box is enabled. The network segment is 10.1.1.1. It is
recommended to keep the default setting.
If the IP camera is from the third party, it must support the Onvif protocol and has enabled
DHCP.
Select Main Menu > SETTING > NETWORK. Step 1
The NETWORK interface is displayed.
Click NETWORK SETTING. Step 2
The NETWORK SETTING interface is displayed.
Configure Switch settings. Step 3
To Next Page
Loading...
