Local Configurations 77
1) Double-click Switch Settings.
The Switch Settings interface is displayed. See Figure 4-60.
Switch settings
Figure 4-60
2) Enter the IP address, subnet mask, and gateway.
The IP address of Switch cannot be in the same network segment with the IP
address of Device. It is recommended to use the default IP address.
3) Click OK.
Select the Switch Settings check box, and then click Save. Step 4
The NETWORK interface is displayed.
Click OK. Step 5
Instructions for PoE Connection
For the PoE connection instructions, see Table 4-28.
Table 4-28 PoE instructions
Use network
Cable to
connect IP
camera to
PoE port
After connecting, the Device configures an IP address to the IP camera.
This IP address is from the network segment where the Switch is located.
Try to configure the IP address by arp ping. If the DHCP function is
enabled, use DHCP to configure the IP address.
After the IP address is configured, a broadcast will be sent from Switch.
If there is any response received, the connection has been established.
Then you can login and find the IP camera. You can find the
corresponding digital channel has been occupied with a small PoE icon
in the top left.
You can view the PoE channel information in the Added Device area in
the REMOTE interface. You can Click IP Search to display or update
the status.
To Next Page
Loading...
