Danfoss VLT AutomationDrive FC 300 Design Guide

3.4.8 Example of Process PID Control 43
3.4.9 Process PID Control Programming Order 44
3.4.10 Optimization of the process regulator 45
3.4.11 Ziegler Nichols Tuning Method 45
3.5 General Aspects of EMC
46
3.5.1 General Aspects of EMC Emissions 46
3.5.2 EMC Test Results 48
3.5.3 Emission Requirements 49
3.5.4 Immunity Requirements 50
3.6 Galvanic Isolation (PELV)
51
3.7 Ground Leakage Current
51
3.8 Brake Functions
52
3.8.1 Mechanical Holding Brake 52
3.8.2 Dynamic Braking 53
3.8.3 Selection of Brake Resistor 53
3.9 Mechanical Brake Control
56
3.9.1 Hoist Mechanical Brake 57
3.10 Smart Logic Controller
59
3.11 Extreme Running Conditions
60
3.12 Safe Stop
62
3.12.1 Safe Torque Off Operation 62
3.12.2 Safe Torque Off Operation (FC 302 only) 62
3.12.3 Liability Conditions 62
3.12.4 Additional Information 62
3.12.5 Installation of External Safety Device in Combination with MCB 112 63
4 Selection
64
4.1 Electrical Data, 380–500 V
64
4.2 Electrical Data, 525–690 V
69
4.2.1 Electrical Data, 525–690 V AC, 12-Pulse 75
4.3 General Specifications
78
4.4 Efficiency
84
4.5 Acoustic Noise
84
4.6 dU/dt Conditions
85
4.7 Special Conditions
86
4.7.1 Manual Derating 86
4.7.2 Derating for Ambient Temperature 87
4.7.3 Automatic Derating 89
Contents Design Guide
Danfoss A/S © Rev. 2014-02-10 All rights reserved. MG34S222

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English