Danfoss VLT AutomationDrive FC 300 Design Guide

9.2.2 Digital Inputs - Terminal X30/1-4 251
9.2.3 Analog Inputs - Terminal X30/11, 12 251
9.2.4 Digital Outputs - Terminal X30/6, 7 251
9.2.5 Analog Output - Terminal X30/8 252
9.3 Encoder Option MCB 102
252
9.4 Resolver Option MCB 103
254
9.5 Relay Option MCB 105
256
9.6 24 V Backup Option MCB 107
258
9.7 PTC Thermistor Card MCB 112
259
9.8 MCB 113 Extended Relay Card
261
9.9 Brake Resistors
263
9.10 LCP Panel Mounting Kit
263
9.11 Sine-wave Filters
264
9.12 High Power Options
264
9.12.1 Frame Size D Options 264
9.12.1.1 Load Share Terminals 264
9.12.1.2 Regeneration Terminals 264
9.12.1.3 Anti-condensation Heater 264
9.12.1.4 Brake Chopper 264
9.12.1.5 Line Power Shield 264
9.12.1.6 Ruggedized Printed Circuit Boards 264
9.12.1.7 Heatsink Access Panel 265
9.12.1.8 Line Power Disconnect 265
9.12.1.9 Contactor 265
9.12.1.10 Circuit Breaker 265
9.12.2 Frame Size F Options 265
10 RS-485 Installation and Set-up
267
10.1 Overview
267
10.2 Network Connection
267
10.3 Bus Termination
268
10.4 RS-485 Installation and Set-up
268
10.4.1 EMC Precautions 268
10.5 FC Protocol Overview
268
10.6 Network Configuration
268
10.6.1 Adjustable Frequency Drive Set-up 268
10.7 FC Protocol Message Framing Structure
269
10.7.1 Content of a Character (Byte) 269
Contents Design Guide
Danfoss A/S © Rev. 2014-02-10 All rights reserved. MG34S222

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English