Datalogic Gryphon I GPS4400 User Manual

Product Reference Guide 5
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are pres-
ent and undamaged. If any damage occurred during shipment, contact Dat-
alogic Technical Support. Information is shown on page 2.
KEEP THE PACKAGING. Should the unit ever require service, it
should be
returned in its original shipping container.
Setting Up the Reader
Follow the steps provided in this section to connect and get your reader up
and communicating with its host.
1. Begin by connecting the scan module to the host. The correct Interface
Sel
ection will occur automatically.
2. If modifications are needed, go to Interface Selection and set the desired
interface.
3. Configure Interface Settings (only if not using factory settings for that
interface)
4. Go to Configuring Other Features (if modifications are needed from fac-
tory settings)

Datalogic Gryphon I GPS4400 Specifications

General

Type	Fixed bar code reader
Sensor type	Laser
Scanner type	2D
Tilt reading angle	-180 - 180 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Input voltage	5 V
USB version	2.0
Standard interfaces	USB, RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Buzzer	Yes
Product color	White
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	73 mm
Width	121 mm
Height	107 mm
Weight	295 g