Datalogic Gryphon I GPS4400 - Central Code Only; Manual Trigger Control

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 71
Manual Trigger Control
This feature is available in Serial On Line mode only.
This feature is used to enable/disable manual trigger when the reader is in
Serial On Line reading mode.
• Enable: allows a manual trigger push to start a reading phase.
• Disable: (default) locks out the trigg
er button and does not allow man-
ual
triggering to start a reading phase. When disabled, the trigger can
still be activated once
by pressing and holding the trigger for 5 sec-
onds to enter Debug Mode.
DEFAULT
$CSOTM00
Manual Trigger Control = Disable
$CSOTM01
Manual Trigger Control = Enable
Central Code Only
Specifies the ability of the reader to decode labels only when they are close
to the center of the aiming pattern. This allows the reader to accurately tar-
get labels when they are placed close together, such as on a pick
sheet.
This feature is not compatible with Multiple Labels Reading in a Volume.
DEFAULT
$CSNPM00(CR)
Central Code Only = Disable
$CSNPM01(CR)
Central Code Only = Enable