Datalogic Gryphon I GPS4400 - Presentation Illumination Control; Scanning Active Time

Enter/Exit Programming Mode Reading Parameters
72 Gryphon™ GPS4400
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON
state once the state is entered. The range for this setting is from 1 to 255
seconds in 1-second increments. See
page 258 in “References” for more.
$CSNET03(CR)
Scanning Active Time = 3 seconds
$CSNET05(CR)
Scanning Active Time = 5 seconds
DEFAULT
$CSNET08(CR)
Scanning Active Time = 8 seconds
Scanning Active Time works in On Line and Serial On Line Read
modes as the Timeout Phase Off Event. See also "
Phase Off
Timeout" on page 69 .
Presentation Illumination Control
Controls the illumination status when in Automatic Trigger Object Sense
Operating Mode and the reader is attempting to detect objects.
DEFAULT
$CSMIL00(CR)
Illumination Control = OFF
$CSMIL01(CR)
Illumination Control = ON
$CSMIL02(CR)
Illumination Control = Dim