Datalogic Gryphon I GPS4400 - No Read Message; No Read String

Data Format Enter/Exit Programming Mode
Product Reference Guide 55
No Read Message
This feature Enables/Disables the No Read Message feature. When Disabled,
nothing is sent if the trigger is pressed and released when no code has been
decoded during a reading phase. Otherwise, the No Read String is sent. (See
"No Read Stri
ng" on page 252 to configure No Read String data)
$CNRSS00\r
Disabled
DEFAULT
$CNRSS01\r
Enabled
No Read String
This feature defines the string or character to be displayed in case of No
Read during a reading phase (On Line and Serial On Line Modes only). It
allows up to 20 characters, from the set of ASCII characters or any hex value
from 00 to FE.
$CNORS
Select No Read String
To configure this feature, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left followed by the
digits (in hex) from the Alphanumeric characters in
Appen-
dix D on page 289
representing your desired character(s).
If less than the expected string of 20 characters are selected,
scan the ENTER/EXIT b
arcode to terminate the string.End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
s
a
ve the entry string. You can then start again at the beginning.
~
CANCEL
DEFAULT
0x18 = (CAN)
See "No Read String" on page 252 for more information on setting this feature.