Datalogic Gryphon I GPS4400 User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 73
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP00(CR)
Aiming Pointer = Disable
$CTAAP01(CR)
Aiming Pointer = Enable
DEFAULT
Aiming Duration Timer
Specifies the time the aiming pointer remains on after decoding a label,
when in On Line or Serial On Line mode.The range for this setting is from 1
to 255 seconds in 1-second increments. See
page 259 in “References”.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code , then the bar code at left
followed by t
he digits from the characters in
Appen-
dix D, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code
again.
M
ake a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
~
CANCEL

Datalogic Gryphon I GPS4400 Specifications

General

Type	Fixed bar code reader
Sensor type	Laser
Scanner type	2D
Tilt reading angle	-180 - 180 °
Pitch reading angle	-40 - 40 °
Linear (1D) barcodes supported	-
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, Micro QR Code, QR Code
Input voltage	5 V
USB version	2.0
Standard interfaces	USB, RS-232
Connectivity technology	Wired
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Buzzer	Yes
Product color	White
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	73 mm
Width	121 mm
Height	107 mm
Weight	295 g