Reading Parameters Enter/Exit Programming Mode
Product Reference Guide
67
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains
on following a good read. The good read LED on time can be set within a
range of 100 milliseconds to 25,500 milliseconds (0.1 to 25.5 seconds) in
100ms increments. A setting of 00 keeps the LED on until the next trigger
push.
See
page 255 in “References” for detailed instructions and examples for
setting this feature.
Good Read LED Duration Setting =
Keep LED on until next trigger push
Select Good Read LED Duration Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at le
ft followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad
representing
your desired character(s). End by scanning the
ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort
and not sa
ve the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
003 = Good Read LED
stays on for 300 ms.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
