Datalogic Gryphon I GPS4400 - China Sensible Code Set Length 2

Enter/Exit Programming Mode 2D Symbologies
180 Gryphon™ GPS4400
China Sensible Code Set Length 2
This feature specifies one of the bar code lengths for China Sensible Code
Length Control. Length 2 is the maximum label length if in Variable Length
Mode, or the second fixed length if in Fixed Length Mode. Characters can be
set from 0001 to 7
,827 characters in increments of 0001 (pad with zeros).
See page 241 for detailed instructions on setting this feature.
$CCSL2
Select China Sensible Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
~
CANCEL
DEFAULT
Length 2 is 7,827 Characters