Datalogic Gryphon I GPS4400 - Individually Set Label ID; Label ID Control

Data Format Enter/Exit Programming Mode
Product Reference Guide 49
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To
set, first define whether you want it as a prefix or suffix by scanning a label
below. Then turn to Label ID Symbology Selection − 1D Symbologies, starting on
page 50 to select the symbology you want to set, followed by up to 3 charac-
ters from the ASCII Chart at the back of this manual. See "Label ID: Set Individ-
ually
Per Symbology" on page 249 for detailed instructions on setting this
feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or
suffix for a given symbology type.
DEFAULT
$CIDCO00(CR)
Label ID Transmission = Disable
$CIDCO01(CR)
Label ID Transmission = Enable as Prefix
$CIDCO02(CR)
Label ID Transmission = Enable as Suffix