Setup Custom Configuration Settings
10
Gryphon™ GPS4400
Custom Configuration Settings
Configure Interface Settings
If your installation requires you to select options to customize your reader,
turn to the appropriate section for your interface type in "Configuration Using
Bar Codes" starti
ng on page 13.
•
RS-232 Only Interface on page 17
•
RS-232/USB-Com Interfaces on page 22
•
USB Keyboard Settings on page 29
Global Interface Features
See "Global Interface Features" on page 15 for settings configurable by all inter-
face types.
Configuring Other Features
If your installation requires different programming than the standard fac-
tory default settings, the following sect
ions of this manual allow configura-
tion of non-interface-specific sett
ings you might require:
Reading Parameters
:
Reading Parameters include programming for scanning,
beeper and LED indicators and other universal settings.
1D Symbologies
:
Includes options concerning the bar code label types (sym-
bologies). These settings allow you to enable/disable
symbologies, set label
lengths, require check digit, etc.
2D Symbologies on page 171 provides configuration of a personalized mix
of 2D codes, code families and their options.
Software Version Transmission
The software version of the device can be transmitted over the interface by
scanning the following label.
Transmit Software Version
To Next Page
Loading...
