Dell EMC PowerEdge T340 DPJ1G - Power Interposer Board; Removing the Power Interposer Board

Figure 75. Installing a cabled power supply unit
Next step
1 Follow the procedure listed in After working inside your system.
Power interposer board
Removing the power interposer board
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the power supply units (PSUs).
CAUTION
: To prevent damage to the power interposer board, you must remove the power supply units or PSU blank from
the system before removing the power interposer board (PIB).
Steps
1 Disconnect all cables connected from the power interposer board (PIB) to the system board, and remove the cables from the cable
retention brackets.
NOTE
: Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it to
prevent the cable from being pinched or crimped.
2 Pressing the release latch on the PIB, lift the PIB to release it from the hooks on the PSU cage.
3 Lift the board and slide it out at an angle to disengage the guide pins on the board.
102
Installing and removing system components