Dell EMC PowerEdge T340 DPJ1G - Removing the Microsd Card; Installing the Microsd Card

3 Follow the procedure that is listed in After working inside your system.
Removing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the air shroud.
4 Remove the IDSDM or vFlash module.
Steps
1 Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2 Hold the MicroSD card and remove it from the slot.
NOTE: Temporarily label each MicroSD card with its corresponding slot number after removal.
Figure 63. Removing the MicroSD card
Next step
1 Replace the MicroSD cards.
Installing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
90
Installing and removing system components