Steps
1 Using the Phillips #2 screwdriver, remove the screw that secures the foot to the base of the system.
2 Repeat the preceding step to remove the remaining system feet.
Figure 19. Removing the system feet
Next step
1 Replace the system feet or install the caster wheels.
Installing the system feet
Prerequisites
CAUTION
: Install the feet on a stand-alone tower system to provide stability to the system. An unstable system might tip over
and cause injury to the user or damage to the system.
1 Follow the safety guidelines listed in Safety instructions.
2 Place the system on its side on a at, stable surface.
Steps
1 Align the three tabs on the system foot with the three slots on the base of the system.
2 Using the Phillips #2 screwdriver, secure the screw that secures the foot to the base of the system.
3 Repeat the above steps to install the remaining system feet.
46
Installing and removing system components
To Next Page
Loading...
