Figure 38. Removing the optical drive or tape drive blank
NOTE: Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certication of the system. The
brackets also keep dust and dirt out of the system and aid in proper cooling and airow inside the system. Perform the same
steps to install blanks.
Next step
Replace the optical drive blank, or an optical drive, or a tape drive.
Installing the optical or tape drive blank
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Remove the front bezel.
Steps
1 Align the guide on the drive blank with the slot on drive bay.
2 Slide the drive into the slot until the latch snaps into place.
Installing and removing system components
65
To Next Page
Loading...
