Dell EMC PowerEdge T340 DPJ1G - Removing the Drive from the Drive Carrier; Installing the Drive into the Drive Carrier

Next steps
1 Install the front bezel.
2 Follow the procedure listed in After working inside your system.
Removing the drive from the drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
CAUTION: Mixing drive carriers from previous generations of PowerEdge servers is not supported.
2 Follow the procedure listed in Before working inside your system.
3 Remove the front bezel.
4 Remove the drive carrier.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
Figure 32. Removing the drive from the drive carrier
Next step
1 Replace the drive into the drive carrier.
Installing the drive into the drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the front bezel.
4 Remove the drive carrier.
Installing and removing system components
59