Removing a drive carrier
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Remove the front bezel.
3 Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator ashes while the drive is turning o. When the drive indicators are o, the
drive is ready for removal. For more information, see the storage controller documentation.
CAUTION: Before attempting to remove or install a drive while the system is running, see the documentation for the
storage controller card to ensure that the host adapter is congured correctly to support drive removal and insertion.
CAUTION: To prevent data loss, ensure that your operating system supports drive installation. See the documentation
supplied with your operating system.
Steps
1 Press the release button to open the drive carrier release handle.
2 Holding the handle, slide the drive carrier out of the drive slot.
NOTE: If you are not replacing the drive immediately, install a drive blank in the empty drive slot to maintain proper system
cooling.
Figure 30. Removing a drive carrier
Next step
Replace the drive or a drive blank.
Installing and removing system components
57
To Next Page
Loading...
Need help?
General