Dell EMC PowerEdge T340 DPJ1G - Drives; Removing a Drive Blank

Figure 27. Installing the intrusion switch
Next steps
1 Install the air shroud.
2 Follow the procedure that is listed in After working inside your system.
Drives
Removing a drive blank
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the front bezel.
CAUTION
: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release tab, and slide the drive blank out.
Installing and removing system components
55