NOTE: Retain the information tag to replace it in the new control panel.
Next step
1 Replace the control panel assembly.
Installing the control panel assembly
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
2 To install the information tag, push the information tag into the control-panel slot.
3 Connect the control panel cable and the control panel USB cable to the control panel assembly.
4 Align and insert the control panel into the control panel slot in the system.
5 Secure the control panel to the system by using the screw.
6 Connect the control panel cable and the control panel USB cable to the system board.
Figure 85. Installing the control panel assembly
Next step
1 Follow the procedure listed in After working inside your system.
112
Installing and removing system components
To Next Page
Loading...
