Figure 68. Applying thermal grease on top of the processor
CAUTION
: Applying too much thermal grease can result in excess grease coming in contact with and contaminating the
processor socket.
NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.
3 Align the screws on the heat sink with the standos on the system board.
CAUTION
: When installing the heat sink, ensure that the airow arrow is pointed towards the rear of the
system.
4 Use a Phillips #2 screwdriver to tighten the screws to secure the heat sink to the system board.
a Tighten the rst screw three turns.
b Tighten the screw diagonally opposite to the screw you tightened.
c Return to the rst screw and tighten it completely.
5 Repeat the procedure for the remaining screws.
Installing and removing system components
95
To Next Page
Loading...
