Copying 235
Making Copies From the ADF
CAUTION: Do not load more than 35 sheets into the ADF or allow more than 35 sheets to be fed to the ADF output tray. The ADF
output tray should be emptied before it exceeds 35 sheets or your original documents may be damaged.
NOTE: To get the best scan quality, especially for gray scale images, use the document glass instead of the ADF.
NOTE: A computer connection is not required for copying.
1
Load up to
35 sheets of 75 g/m
2
(20 lb)
documents face up on the ADF with top edge of the documents in first.
Then adjust the document guides to the correct document size.
NOTE: Ensure that you use the document guides before copying a legal-size document.
2
Customize the copy settings including the number of copies, copy size, contrast, and image quality. For more
information, see "Setting Copy Options" on page 235.
To clear the settings, use the
AC (All Clear)
button.
3
Press the
(Start)
button to begin copying.
NOTE: Press the (Cancel) button to cancel a copy job at any time while scanning a document.
Setting Copy Options
Set the following options for the current copy job before pressing
the
(Start)
button to make copies.
NOTE: The copy options automatically return to their default status after copying.
Number of Copies
To specify the number of copies from 1 to 99.
1
Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document glass, and close the document cover.
For details about loading a document, see "Loading an Original Document on the ADF" on page 272.
2
Press the
(Copy)
button.
3
Enter the number of copies using the numeric keypad to select the desired value.
4
Press the
(Start)
button to begin copying.
To Next Page
Loading...
Need help?
General
