Understanding the Printer Menus 181
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Receive Mode
Purpose:
To select the default fax receiving mode.
Va lu es :
Auto Rec Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call. The interval
can be specified within the range of 0 to 255 seconds. The default is 0 second.
Auto Rec TEL/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external telephone receives an
incoming call. The interval can be specified within the range of 0 to 255 seconds. The default is 6 seconds.
Auto Rec Ans/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external answering machine receives
an incoming call. The interval can be specified within the range of 0 to 255 seconds. The default is 21 seconds.
Telephone Automatic fax reception is turned off. You can receive a fax by picking up the handset of the
external telephone, and then pressing the remote receive code.
FAX* Automatically receives faxes.
Telephone/Fax When the printer receives an incoming fax, the external telephone rings for the time specified in
Auto Rec TEL/FAX, and then the printer automatically receives a fax. If an incoming call is
not a fax, the printer beeps from the internal speaker indicating that the call is a telephone call.
Ans Machine/Fax The printer can share a telephone line with an answering machine. In this mode, the printer will
monitor the fax signal and pick up the line if there are fax tones. If the phone communication is
using serial transmission in your country (such as Germany, Sweden, Denmark, Austria, Belgium,
Italy, France and Switzerland), this mode is not supported.
DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service
must be installed on your telephone line by the telephone company. After the telephone company
has provided a separate number for faxing with a distinctive ring pattern, configure the fax setup
to monitor for that specific ring pattern.
To Next Page
Loading...
Need help?
General
